// Q&A · Track Tension & Alignment
How do you fix excavator track tension when the track keeps going slack?
Expert Answer
Loose excavator track tension is usually corrected by adding grease to the track adjuster, but if the track goes slack again, the adjuster, relief valve, or seal may be leaking and needs inspection. First clean the adjuster area, then check for grease loss, damaged fittings, bent hardware, or a front idler that is not moving smoothly.
To adjust it properly, always follow the machine’s service manual for the correct procedure and target sag. Over-tightening is a common mistake: it can increase wear on rollers, idlers, sprockets, and track links, while a track that is too loose can ride off the sprocket or derail on turns. If one side loosens repeatedly, compare both sides and look for uneven wear, debris packed in the undercarriage, or a worn recoil system.
If the adjuster will not hold tension after greasing, the cylinder seal or valve may be failing. In that case, tension adjustment alone will not solve the problem; the leaking component must be repaired or replaced. VANROCK supplies undercarriage parts through its dealer network, and exact fitment and pricing are quoted on request.
Answered by VANROCK specialists · Published 11/17/2026
Need This Part?
VANROCK manufactures premium undercarriage parts for 9,000+ machine models
Related Questions
- How do you measure excavator track tension and know if it is too tight or loose? →
- How do you use an excavator track tension tool to check and adjust track tension? →
- How do you adjust excavator track tension with the proper tool? →
- How do you adjust excavator track tension with grease and know if it is too tight or loose? →
- How do you adjust mini excavator track tension and know if it is too tight or too loose? →
- How do I adjust track tension on an excavator and know if it is too tight or too loose? →

